Are you looking for a small prototyping platform that is easy to move around and does not take up much space?
Look no further! Our new Pi Zero prototyping case has a larger bottom layer to make room for a standard 400 tie-point half size breadboard (included). Whipping up a quick prototype is super easy and if you have to move it just pick up the case and off you go.
This Raspberry Pi Zero case consists of three unique acrylic layers (clear and colour) with a transparent top and base. Each layer is laser cut from high quality cast acrylic and once stacked they securely contain a Raspberry Pi while leaving the primary ports accessible including GPIO, RUN and RCA headers including Micro SD card port and camera port. GPIO, RUN and RCA headers on this Raspberry Pi Zero case are also accessible from the bottom so you can choose wether you want to solder the 40 pin header on the top or bottom.
Case is lightweight and ideal for mounting to any surface. It is held together by nylon bolts and nuts no tools are required for assembly or disassembly. These nylon nuts double up as small feet for the case.
This case is fully compatible with the Raspberry Pi Zero INCLUDING V1.3 WITH THE CAMERA CONNECTOR.
Note: By default the middle (coloured) layer will be clear, but you can choose any colour from our Pi Zero case range. Just make sure you leave us a message during the checkout.
Compatible with Raspberry Pi Zero
Super slim profile
Larger base plate to accommodate half size breadboard.
Dimensions: 120mm (L) x 34mm (W) x 11mm (H excluding nylon screws)
Easy to assemble (no tools required)
All primary ports accessible including SD card and camera connector
Made out of high quality birch plywood and acrylic
1 x Raspberry Pi Zero Case
1 x 400 tie-point breadboard
4 x screws and nuts